ADDRESS


EMAIL

PHONE

Headlights Toyota Tacoma 2003 Installation

2003 tacoma headlightsYou now have you in the insulation article for 2003 and up to you Toyota Tacoma a projector headlights. These are the set of tools that we recommend for the installation. We will start by opening up the hood of your vehicle. Please locate the 2 red arrows removed it to 10000000. Screws as you see here in the video. Please remove the 2 plastic clips. The next step is to remove the front grill by pulling it upwards. Please remove the plastic clips located in the corner of the headlight assembly.

Below the headlight you are able to remove the headlight garnish. At the top of the front bumper locate 3 plastic clips as you see in the video and go ahead and remove those. Remove the 10 millimeters screw. Coordinates the fender well and you will remove the plastic clip as you see here in the video. Gently pull the inner fender liner aside. The You will find a 10 millimeter full and you remove it.

On your headlight bracket remove to 10 millimeter screws. Now gently disconnect the light sockets and had like harnesses from the headlight. You are free to remove this stock headlight. And. This. Connect the light sockets and headlight harnesses. 2003 Tacoma headlights that place it in the stock location. You now tighten everything back together in the reverse order please carefully review this. Make sure your Toyota Tacoma lights are working properly.